The most popular software defined radio in the world began life as a cheap digital TV tuner. Hobbyists discovered that the raw radio data inside USB dongles built on the RTL2832U chip could be read directly, and the RTL-SDR project’s own history of the dongle credits that discovery with turning a mass-produced TV stick into a wideband receiver.
That story explains what software defined radio (SDR) is. A conventional radio does its tuning, filtering and demodulating in dedicated circuits. An SDR does only the minimum in hardware, turns the radio signal into numbers, and lets software on a computer do the rest. Change the software and the same box can receive FM, AM, single sideband, aircraft position beacons or weather satellite pictures. This guide covers what a dongle can and cannot do, what you actually see on screen, the legal line every listener should know, and a three-step way to start.
Hardware does less, software does more
The general definition, as summarised in the Wikipedia entry on software-defined radio, is a radio in which parts that were traditionally hardware, such as mixers, filters, modulators and demodulators, are implemented in software on a computer or embedded system. A basic system is an RF front end feeding an analogue-to-digital converter, followed by a general-purpose processor.
Here is the split in a typical listening setup:
| Job | Traditional radio | Software defined radio |
|---|---|---|
| Pick up the signal | Antenna | Antenna |
| Amplify and select a slice of spectrum | Tuned circuits | Tuner chip in the dongle |
| Convert to digital | Not done (or only in digital sets) | Analogue-to-digital converter in the dongle |
| Filter, demodulate, play audio | Dedicated circuits | Software on your computer |
| Change modes or decode data | Needs a different radio | Install or switch software |
If the AM and FM part of that table is hazy, our explainer on how AM and FM radio work fills it in first.
What a cheap dongle can and cannot do
Knowing the limits up front saves you a disappointing first evening.
It can
- Cover a very wide range. RTL-SDR’s published figures put the common R820T and R828D based dongles at roughly 24 to 1,766 MHz, with some models adding hardware tweaks for reception below 24 MHz.
- Show a slice of spectrum at once. The site gives a maximum sample rate of 3.2 MS/s, with about 2.56 MS/s as the highest rate that does not drop samples. In practice that means a window a couple of megahertz wide on screen.
- Decode data, not just voice. The project lists aircraft position (ADS-B), ship position (AIS), weather satellite images and pager decoding among common uses.
It cannot
- Transmit. The RTL-SDR site states plainly that these dongles cannot transmit. Some more expensive SDRs can, and using one to transmit needs the right licence.
- Hear encrypted traffic. Software cannot decode encrypted digital voice, and trying to would be illegal in most places.
- Beat a poor antenna. The small telescopic antenna in many kits is a starter. Reception improves more from a better antenna in a better position than from any software setting.
- Match a premium receiver on strong-signal handling. The Wikipedia entry notes that real converters lack the dynamic range for the tiny signals an antenna delivers, so an amplifier comes first, and strong nearby signals can then overload it. That is why a city-centre setup can show phantom signals.
Reading the screen: spectrum and waterfall
Most SDR programs show two panels, and they are the main reason people fall for SDR.
- The spectrum display is a live graph. Frequency runs left to right, signal strength runs up. A broadcast FM station looks like a wide hump; a narrow voice channel looks like a thin spike.
- The waterfall sits underneath and scrolls down over time. Each signal leaves a coloured trail, so you can see a burst of activity that happened ten seconds ago, which a traditional radio would have missed.
Click on a trace, choose the mode (WFM for broadcast FM, NFM for narrow FM voice, AM, USB or LSB), and adjust the filter width until the audio is clean. That click-and-listen loop is the core skill.
The legal line every listener should know
Owning a receiver is one thing. What you may listen to is another, and it depends on where you live.
- United Kingdom. Section 48 of the Wireless Telegraphy Act 2006 makes it an offence, without lawful authority, to use wireless apparatus with intent to obtain information about the contents, sender or addressee of a message you are not an intended recipient of. Broadcast stations are meant for the public; many other signals are not.
- United States and elsewhere. The rules differ by country and, for some uses such as scanners in vehicles, by state. Our guide to radio scanners and the law covers the main differences.
The RTL-SDR site carries its own warning that not every application it lists may be legal in your country. Take that seriously. Broadcast radio, amateur radio and weather satellite images are the safest places to start almost anywhere.
A three-step starter path
Step 1: Get a receiver and a better antenna position
A dongle from the RTL-SDR family is the usual entry point. Put the antenna by a window or outdoors on a short cable rather than on the desk next to the computer, which is a noisy place.
Step 2: Install one program and learn it
Pick one of the widely used free programs for your operating system and stay with it for a week. Learn three things: setting the centre frequency, choosing the mode, and adjusting the gain. Too much gain is the most common cause of a messy display.
Step 3: Work through easy targets in order
- Broadcast FM. Strong, wide signals that prove the setup works.
- Amateur radio. Local repeaters on VHF and UHF, then single sideband on HF if your dongle reaches below 24 MHz. Our piece on getting started with amateur radio explains the bands.
- Data signals you are allowed to decode where you live, such as weather satellite images.
If you record what you hear, the audio is often hissy. The same tools used to remove background noise from audio recordings can clean up a saved clip, though nothing replaces a stronger signal at the antenna.
Frequently Asked Questions
Is software defined radio better than a normal radio?
For flexibility and seeing what is on the air, yes. For simply listening to one station in the kitchen, no. An SDR needs a computer or phone, software and a bit of learning. A good portable radio switches on and plays. Many listeners keep both: a normal set for everyday listening and an SDR for exploring.
Do I need the internet to use an SDR dongle?
No. A USB dongle receives radio directly from its own antenna, and the RTL-SDR site describes it as working with no internet required. You only need the internet to download the software. Web-based SDRs are different: they let you listen to someone else’s receiver over the internet.
Can an SDR receive shortwave and AM broadcasts?
Many can, but check the model. Standard dongles start around 24 MHz, which is above the shortwave broadcast bands. Some models add direct sampling or built-in upconversion to reach lower frequencies, and dedicated HF-capable SDRs cover them natively. A long wire antenna helps a great deal on these bands.
Can I use an SDR on a phone?
Often, yes. Android phones that support USB host mode can run some SDR apps with a dongle and an adapter. It drains the battery quickly, and the phone’s own electronics add noise, so keep the dongle and antenna a short cable away from it.
Is it legal to own an SDR?
Owning a receive-only SDR is legal in most countries. The legal questions are about what you listen to and what you do with it, and they vary by country. In the UK, intercepting messages you are not meant to receive is an offence under the Wireless Telegraphy Act 2006. Check your own national rules before decoding anything beyond broadcast and amateur signals.