---
title: "LED Lights Causing Radio Interference? Find and Fix It | Radio Explained"
description: "LED lights causing radio interference? A 10-minute test to find the noisy bulb, why cheap drivers buzz on AM, fixes cheapest first, and the FCC rule on it."
image: "https://nareshradio.com/wp-content/mu-plugins/nrseo-og-placeholder.png"
---

# LED Lights Causing Radio Interference? Find and Fix It

[Troubleshooting](https://nareshradio.com/category/troubleshooting/)

You fit a new set of LED bulbs in the kitchen, switch them on, and the AM talk station you have listened to for years disappears under a rasping buzz. Switch the lights off and the station comes back. That pattern is the giveaway: the bulbs, or the small power supplies inside them, are radiating electrical noise that your radio picks up as if it were a signal.

The fix is usually cheap once you know which light is to blame. This guide gives you a ten-minute test to find the culprit, explains why some LEDs are much noisier than others, lists the fixes in the order worth trying, and covers what the rules say if the noise is coming from next door.

## The ten-minute test that finds the noisy light

You need a battery-powered AM radio, because a mains radio can pick up noise through its own power lead and confuse the result.

1. **Tune to the problem.** Pick a spot on the AM dial between stations, near the low end, where the buzz is loudest. Turn the volume up.
2. **Switch off lights one at a time.** Wait two seconds after each switch. When the buzz drops, you have found a source. Keep going, because there is often more than one.
3. **Use the radio as a direction finder.** Walk slowly around the house holding the radio. The noise grows as you approach the source and peaks within a metre or so of it. Rotating the radio also changes the level, because the ferrite rod inside an AM set is directional.
4. **Kill the whole house if needed.** If the noise survives every light switch, turn off the main breaker briefly. If it is still there with your power off, it is coming from outside your home.

Write down what you find. Noise that comes and goes on a timer, or rises at dusk, often points to outdoor security lights or a neighbour’s lighting rather than your own.

## Why an LED bulb can sound like a chainsaw on AM

An old filament bulb is just a hot wire. An LED bulb is an electronic device: the LEDs need low-voltage direct current, so every bulb hides a tiny power supply, often called the driver, that chops the mains supply at high speed. That rapid switching produces radio-frequency energy, and the house wiring can act as an antenna that carries it around.

A well-designed driver filters most of that energy away. A cheap one may skip the filtering to save a few cents. The ARRL, the US national association for amateur radio, says on its [lighting devices page](https://www.arrl.org/lighting-devices) that it receives numerous reports of interference from lighting, driven by the spread of energy-efficient LED lighting and by grow lights with high-power ballasts.

The AM band and shortwave suffer most, because these lower frequencies are where switching noise is strongest and where broadcast signals are often weakest. FM is more resistant but not immune, and a noisy driver can also hurt DAB reception on a set with a weak signal. If you want the wider picture of how electrical noise reaches a receiver, our guide to [radio frequency interference and its causes](https://nareshradio.com/radio-frequency-interference-causes-types-and-how-broadcasters-manage-it/) covers the main types.

## Which lights cause the most trouble

| Source | Typical symptom | Why |
|---|---|---|
| Unbranded or very cheap LED bulbs | Steady buzz across the AM band | Minimal filtering in the driver |
| Dimmable LEDs on an older dimmer | Buzz that changes with the dimmer setting | Dimmer and driver fight each other |
| LED strip lights with a plug-in power supply | Noise near the power brick and along the strip | Switching supply plus a long, unshielded lead |
| Outdoor floodlights and security lights | Noise at night, or on a motion trigger | Often cheap drivers, long cable runs outdoors |
| Grow lights | Strong, wide noise reaching shortwave | High-power ballasts named by the ARRL as a common cause |
| Seasonal light sets and their controllers | Noise only in December | Controllers and adapters with switching supplies |

Ceiling fans with LED light kits deserve a special mention, because the light, the remote receiver and the speed control all sit in one box near the ceiling. If you are already planning to replace a noisy fitting, this breakdown of [what it costs to have a ceiling fan installed](https://1hsc.com/how-much-does-it-cost-to-install-a-ceiling-fan/) helps you budget for the swap.

## Fixes, cheapest first

1. **Swap the noisy bulb for a different brand.** Take the radio to the shop or test one bulb at home before buying a whole pack. Bulbs from a known maker are not guaranteed quiet, but the ones you test are.
2. **Move the radio.** Noise falls off quickly with distance. Moving a portable two or three metres away from the fitting, or to another wall, can be enough.
3. **Turn the radio.** On AM, rotate the set until the buzz is weakest and the station holds.
4. **Clip a ferrite onto low-voltage leads.** For LED strips and plug-in adapters, a snap-on ferrite core on the DC lead close to the power supply can reduce the noise that lead radiates. Loop the cable through the core two or three times if it fits.
5. **Replace the dimmer.** If the noise follows the dimmer, fit one rated for LED loads, or use non-dimmable bulbs on that circuit. Have an electrician do this if you are not qualified.
6. **Get the antenna away from the house wiring.** For a home stereo or a dedicated listening post, an outdoor or loft antenna well away from lighting circuits will pick up far less household noise.
7. **Change band for that station.** If the station also has an FM simulcast, a DAB service or a stream, use it in the room with the problem lights.

Never open an LED bulb or a power supply to add filtering yourself. They run at mains voltage, and the internal capacitors can hold a charge after switch-off.

## Is the buzz coming from your neighbour?

If your own breaker test leaves the noise untouched, walk the street with the portable radio. Be friendly and specific when you knock: “The noise on my radio stops when your porch light goes off” is easier to hear than a complaint about interference.

In the US, the general condition in [47 CFR 15.5](https://www.ecfr.gov/current/title-47/section-15.5) says a device that radiates radio energy may only be operated if it causes no harmful interference, and that its operator must stop using it if notified by the FCC that it is causing harmful interference, until the problem is corrected. In practice most cases are settled between neighbours, and the ARRL says many interference cases are resolved before formal action is needed. Licensed amateurs in the US can also ask the ARRL for help with the process.

In the UK, Ofcom is the regulator responsible for radio spectrum, and its website is the place to check how to report interference to broadcast reception and what it will investigate, since that guidance changes from time to time.

Whatever the jurisdiction, it is worth ruling out your own home first. Our checklist on [why radio reception goes bad](https://nareshradio.com/why-radio-reception-is-bad/) covers the other common causes, from weak signals to a loose antenna, so you do not blame the lights for something else.

## Quick check before you buy replacement bulbs

- Bring a pocket AM radio to the shop, or buy one bulb to test first.
- Test with the bulb in the fitting where it will live, at the dimmer setting you actually use.
- Listen on AM between stations, then on the specific station you care about.
- Keep the receipt until you have tested at night, when AM signals and noise both change.

## Frequently Asked Questions

### Can LED lights interfere with FM radio as well as AM?

Yes, though it is less common. FM is more resistant to the kind of noise LED drivers produce, so most people notice the problem on AM first. A very noisy bulb close to a radio with a weak FM signal can still cause hiss, loss of stereo or dropouts. The same test works: switch lights off one at a time and listen for the change.

### Do smart bulbs cause more interference than ordinary LEDs?

Not necessarily. A smart bulb has the same kind of driver as an ordinary LED plus a small wireless radio, so it can be quiet or noisy depending on design. Its own Wi-Fi or Bluetooth signal is far above the broadcast bands and rarely affects AM or FM. Test any bulb before you fit a whole house with it.

### Will a surge protector or extension lead filter the noise?

A basic surge protector is not designed to filter radio-frequency noise, so it rarely helps much. Some power strips include a mains filter, which may reduce noise reaching a radio through its own power lead, but it does nothing about noise radiated by the lighting wiring in the walls. Moving the radio or replacing the noisy bulb is usually more effective.

### Why is the interference worse at night?

Two things happen at once. More lights are on, including outdoor and security lights that may be the source. And on AM, distant stations reach you by skywave after dark while local signal conditions change, so a station you are trying to hear may be weaker against the noise. Try the switch-off test in the evening as well as in daylight.

### Related Articles

📻

[How to identify a blown fuse](https://nareshradio.com/how-to-identify-blown-fuse/)

A blown fuse is a common cause of equipment that s…

📻

[Audio hum: causes and fixes](https://nareshradio.com/audio-hum-causes-fixes/)

A low hum from audio equipment is one of the most…

### Recently Published

- [WiFi Internet Radios: How They Work and What to Check](https://nareshradio.com/wifi-internet-radio-guide/)
- [How to Listen to Thanksgiving NFL Games on the Radio](https://nareshradio.com/thanksgiving-nfl-games-radio/)
- [How to Become a Radio DJ: Realistic Routes Into Presenting](https://nareshradio.com/become-radio-dj-routes/)
- [How Old Is My Radio? Dating a Vintage Set From Clues](https://nareshradio.com/date-vintage-radio-age/)
- [Where to Listen to Old Time Radio Shows Free (Legally)](https://nareshradio.com/old-time-radio-free-listening/)
- [LED Lights Causing Radio Interference? Find and Fix It](https://nareshradio.com/led-bulbs-radio-interference/)
- [Black Friday Radio Deals: Specs to Check Before You Buy](https://nareshradio.com/black-friday-radio-deals-checklist/)
- [Why Some New Cars Have No AM Radio (and What Is Changing)](https://nareshradio.com/new-cars-no-am-radio/)
- [How to Use a CB Radio: Channels, Etiquette and First Call](https://nareshradio.com/how-to-use-cb-radio/)
- [How to Sync Christmas Lights to an FM Radio Station](https://nareshradio.com/sync-christmas-lights-fm-radio/)
- [GMRS License: How to Apply, What It Costs, Who It Covers](https://nareshradio.com/gmrs-licence-how-to-apply/)
- [How to Study for the Ham Radio Technician Exam (2-Week Plan)](https://nareshradio.com/pass-technician-exam-study-plan/)
- [How to Listen to a Police Scanner Online (and Its Limits)](https://nareshradio.com/listen-police-scanner-online/)
- [SSB on a Shortwave Radio: What It Is and Why You Want It](https://nareshradio.com/ssb-shortwave-radio-explained/)
- [What Is Software Defined Radio? A Plain Guide for Listeners](https://nareshradio.com/what-is-software-defined-radio/)

### Topics

- [Audio](https://nareshradio.com/category/audio/) (3)
- [Broadcasting &amp; Stations](https://nareshradio.com/category/broadcasting/) (48)
- [Cables &amp; Connectors](https://nareshradio.com/category/cables-connectors/) (1)
- [Electronics Basics](https://nareshradio.com/category/electronics-basics/) (2)
- [Hobby &amp; Licensing](https://nareshradio.com/category/hobby-and-licensing/) (5)
- [How Radio Works](https://nareshradio.com/category/how-radio-works/) (21)
- [Listening](https://nareshradio.com/category/listening/) (126)
- [Receivers &amp; Gear](https://nareshradio.com/category/receivers-and-gear/) (9)
- [Reception &amp; Antennas](https://nareshradio.com/category/reception-and-antennas/) (4)
- [Speakers](https://nareshradio.com/category/speakers/) (3)
- [Troubleshooting](https://nareshradio.com/category/troubleshooting/) (3)

```json
[
    {
        "@context": "https://schema.org",
        "@type": "Article",
        "headline": "LED Lights Causing Radio Interference? Find and Fix It",
        "description": "LED lights causing radio interference? A 10-minute test to find the noisy bulb, why cheap drivers buzz on AM, fixes cheapest first, and the FCC rule on it.",
        "url": "https://nareshradio.com/led-bulbs-radio-interference/",
        "datePublished": "",
        "dateModified": "",
        "author": {
            "@type": "Organization",
            "name": "nareshradio.com"
        },
        "publisher": {
            "@type": "Organization",
            "name": "nareshradio.com",
            "url": "https://nareshradio.com"
        },
        "mainEntityOfPage": {
            "@type": "WebPage",
            "@id": "https://nareshradio.com/led-bulbs-radio-interference/"
        }
    },
    {
        "@context": "https://schema.org",
        "@type": "BreadcrumbList",
        "itemListElement": [
            {
                "@type": "ListItem",
                "position": 1,
                "name": "Home",
                "item": "https://nareshradio.com/"
            },
            {
                "@type": "ListItem",
                "position": 2,
                "name": "Troubleshooting",
                "item": "https://nareshradio.com/category/troubleshooting/"
            },
            {
                "@type": "ListItem",
                "position": 3,
                "name": "LED Lights Causing Radio Interference? Find and Fix It",
                "item": "https://nareshradio.com/led-bulbs-radio-interference/"
            }
        ]
    }
]
```
